Philips MC77 - Manual (Page 26)

i
Clock/Timer
Timer Setting
The system can switch on to CD.TUNER, or
TAPE mode automatically at a fjreset time,
serving as an alarm to wake you up.
IMPORTANTt
— Before seWng the timer, ensure that the
clock is set correctly.
— The timer will always be switched on
after it has been set,
— The timer will not start If a recording is in
progress.
— The volume of the timer will increase
gradually from the minimum level to the
last tuned volume level.
Press and hold TIMER on the remote control
for more than two seconds.
"Hh Id - 00" or "00 ■00” or the last timer
setting starts flashing.
TIMER 0 starts flashing.
The selected source will be lighted while
other available sources are flashing.
Press CD 1*2»3, TUNER or TAPE to select
the desired source.
Before setting the timer, make sure the music
source has been prepared.
CD 1 «2»3 - Load the disc(s).1b start from a
specific track, make a programme (refer to "CD
Operation - Programming the disc tracks").
TUNER - tune to the desired radio station.
TAPE - load a prerecorded tape.
Press « or ►► repeatedly to set the hour for
the timer to start
Press M or ►! repeatedly to set the minute for
the timer to start
Press TIMER to store the start time.
^ "TIMER ON" is displayed, followed by the
set timer "XX ■ .XX" and the selected source.
TIMER 0 remains on the display.
At the preset time, the selected sound source
wilt play.
To exit without storing the setting
Press ■ on the system.
Notes:
— /f CD is the selected source and it is not
available when the preset time is reached,Tuner
will be selected automatically.
— Ounng timer setting, if no button is pressed
within 90 seconds, the system will exit timer setting
mode automatically.
Checking the timer
Press TIMER on the remote control.
^ If the timer has been activated, the set timer
information is displayed.
Activating/deactivating the timer
Press TIMER ON/OFF repeatedly on the
remote control.
If activated, the last set timer information is
displayed for a few seconds,
timer
0 is shown.
If deactivated, "OFF" is displayed.
Sleep timer setting
The sleep timer enables the system to switch to
standby mode automatically at a preset time.
Press SLEEP on the remote control repeatedly
to select a preset amount of time.
^ The selections are as follows (time in
minutes):
15 — 30 — 45 — 60 ^ OFF ^ 15 ...
-♦ "SLEEP -X.X" or "OFF" is displayed. ".X.X" is
the time in minutes.
When you reach the desired length of time, stop
pressing the SLEEP button.
^ SLEEP is shown, except for "OFF" mode.
The Sleep Timer is now set Before the
system switches to standby mode, a countdown
of 10 seconds is displayed.
"SLEEP 10" "SLEEP 9".... -
•SLEEP I" - "SLEEP"
26