Philips MC77 - Manual (Page 18)

в
CD Operation
Randotn play
1 Press SHUFFLE on the remote control.
-+ SHUFFLE is shown and "SHUFFLE" is
displayed.
All the available discs or programmed tracks
(if programme is active) wilt be played in random
order
2 To resume normal playback, press SHUFFLE
again.
^ SHUFFLE disapp>ear5.
Notes:
— Selecting SHUFFLE during repeat playback will
cancel all repeat modes.
— Pressing the CD OPEN*CLOSE button will cancel
all repeat and shuffling modes.
Programming the disc tracks
Programming tracks is possible when playback is
stopped. Up to -40 tracks can be stored in the
memory in any order
1 Load the desired discs on the disc trays (refer to
"Loading Disc").
2 Press PROG to start programming.
PROGRAM starts flashing.
3 Press CD 1*2«3 or CD DIRECT 1/2/3 button
to select a disc.
4 Press M or H repeatedly to select the desired
track.
5 Press PROG to store the track
0 Repeat steps 3—5 to store other discs and
tracks.
6 To end programming, press ■ once.
PROGRAM stays and the programme mode
remains active.
“♦ The total number of tracks programmed and
the total playing time are displayed.
7 Press PLAY ► ( ► II) to start programme
playback
*♦ *i-'LRT PROGRRH" is displayed.
Notes:
— If the total playing time is more than "33-БЗ"
or if one of the programmed tracks has a number
greater than 30, then is displayed
instead of the total pdaying time.
— If you attempt to programme more than 40
tracks, "PROGRRH FULL " is displayed.
— If you press any of the CD DIRECT 1/2/3
buttons on the remote control, the system vdll play
the selected disc or track, and the stored
programme wi/i be ignored temporarily. The
PROGRAM symbol also will disappear temporarily
from the display. It will reappear when playback of
tfie selected disc ends.
— During programming, if no key is pressed within
20 seconds, the system w/// exit the programme
mode automatically.
To review Che programme
Stop playback and press M or H repeatedly.
To exit review mode, press ■.
Erasing the programme
Press ■ once when playback is stopped or
twice during playback
PROGRAM disappears and ’F'RCfGRRH
CLEARED" is displayed.
Nate:
— The programme will be erased when the system
is disconnected from die power supply or when the
disc tray is opened.
For Recording, please refer to **Tape
Operation/Recording^*.
18