Philips MC77 - Manual (Page 12)

Basic Functions
M I C R O S V S T R K
o
vm mr J rv ixf
I N S T R L i
□□□DaDDQDI
ca U3 TUNOl TAfC AtMiCM
5 o
# 5 5
O 0>
IMPORTANT!
Before operating the system, complete the
preparation procedures.
Plug and Play
Plug and Play allows you to stone all available
RDS stations and radio stations automatically.
First time setup/power up
When you turn on the main supply, "HlJTO
INSTALL - PRESS FLAT" is displayed.
Press PLAY ► ( ►11) on the system to start
installation.
-♦ "INSTALL" is displayed, followed by
"TUNER" and "AUTO".
^ PROGRAM starts flashing.
The system will automatically store the radio
stations with sufficient signal strength, starting
from all RDS stations and followed by FM, MW
and LW bands respectively. Weak RDS stations
may be stored in later presets.
When all the available radio stations are
stored or the memory for 40 presets are used,
the last preset radio station (or the first available
RDS station) will be played.
The system will proceed to set the RDS clock If
the first preset is an RDS station.
-♦ "INSTALL" is displayed, followed by
"TINE" and "SEARCH RDS TINE".
When RDS time is read, "RDS TINE" is
displayed and the current time will be stored.
If RDS station does not transmit RDS time
within 90 seconds, the programme will exit
automatically and the display will show
"NO RDS TINE".
if the first preset is non-RDS station;
^ The programme will exit automatically.
To reinstall Plug and Play
In standby or demonstration mode, press and
hold PLAY ►(►■!) on the system until
"AUTO INSTALL - PRESS PLAT" is
displayed.
Press PLAY ► ( ► II) again to start installation.
^ All previously stored radio stations will be
replaced.
To exit without storing the Plug and Play
Press ■ on the system.
^ If you do not complete the Plug and Play
installation, the function will be restarted when
you next turn on the main supply again.
12