Clock setting, Lb exit without storing the setting, Display clock – Philips MC77 User Manual

Page 25: Clock setting display clock, Clock/timer

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Clock/Timer

H I C R O S Y S T C I

^ANDfiY-ON

I __^ 1 h / i

i I I

FW 05

I r-i. lu o

' :

□□□□□□□□□

IMPORTANTi

When in Eco Power standby mode, ft is not

possibie to operate the clock or timer

function.

Clock setting

The clock can be set in either 12-hour or

24-hour mode ("HM IS ■ 00" or "00 ■ 00" for

example)

Press and hold CLOCK on the remote control

until the time flashing on the display.

Press PROG repeatedly to select clock mode.

"Rfl XX=XX" or "XX:XJX" starts flashing.

Press -44 or ►► repeatedly to set the hour.

Press M or W repeatedly to set the minute.

Press CLOCK again to store the setting.

“> The clock will start working.

lb exit without storing the setting

Press ■ on the system.

0-^ e ©

o o

Notes;

— The dock setting will be cancelled when the

power co«i is disconnected or If a power failure

occurs.

~ During dock setting, if no button is pressed

within 90 seconds, the system will exit dock setting

mode automatically.

— To set the dock automatically through the time

in/brmadon in the RDS signal, refer to "Radio

Reception - Setting the RDS dock”.

Display clock

The system allows you to select clock display or

normal display in any source mode (except Eco

Power standby mode). When in standby mode,

the clock will automatically be displayed.

Press CLOCK on the remote control

repeatedly to select clock display or normal

display mode.

If the clock has not been s

displayed.

Note:

— If you pressed any buttons during dock display

mode, the display will briefly show the information

related to the selected mode.

This manual is related to the following products:

MC7737