Philips FWC87037 - Manual (Page 26)

Clock/Timer
2 Press CD, TUNER or TAPE to select the
desired source.
• Make sure the music source has been prepared
CD “ load the disc{s).To start from a specific
track, make a program (refer to "CD Operation -
Programming the disc tracks”).
TUNER - tune to the desired radio station.
TAPE - load the prerecorded tape into tape
deck 2.
3 Press ^ or ►► on the system repeatedly to set
the hour for the timer to start
4 Press M or w on the system repeatedly to set
the minute for the timer to start
5 Press CLOCK/TIHER to store the start time.
H The timer is now set and activated.
TIMER wifi remain on the display.
• At the preset time, the selected source will play.
To exit without storing the setting
• Press B on the system.
Notes;
- If the selected source (CD or TAPE) is not
available when the preset timer is reoched, TUNER
will be selected automaticoliy.
- During timer setting, if no button is pressed
within 90 seconds, the system wifi exit timer setting
mode automatkally.
To deactivate the TIMER
• Press TIMER ON/OFF on the remote control
-» The display will show tRtJiCi’ and timer
will disappear from the display.
To activate theTIMER
• Press TIMER ON/OFF on the remote control
The last set timer information will be shown
for a few seconds and timer ® will appear on
the display.
Sleep Timer Setting
The sleep timer enables the system to switch to
Standby mode automatically at a preset time.
1 Set the clock (refer to "Clock Setting").
2 Press SLEEP on the remote control repeatedly
to select a preset time.
^ The selections are as follows (time in
minutes);
B D - 4 S - 3 D - I S - O T F - B O . . .
“SLECP ;:i:" ortirr" will be displayed.
is the time in minutes.
3 When you reach the desired length of time, stop
pressing the SLEEP button.
-♦ The Sleep Timer is now set After this
amount of time passes, the system will switch to
Standby mode.
To deactivate the Sleep Timer
• Press SLEEP repeatedly until TjPr" is displayed,
or press the STANDBY ON button.
26