Philips FWC87037 - Manual (Page 10)

Preparations
FM Antenna
For better FM stereo reception, connect an
outdoor FM antenna to the FM ANTENNA
terminal.
) Speakers Connection
Front Speakers
Connect the speaker wires to the SPEAKERS
(FRONT) terminals, right speaker to "R" and left
speaker to "L", colored (marked) wire to" +"
and black (unmarked) wire to"
• Clip the stripped portion of the speaker wire as
shown.
Notes:
- For optimal sound performance, use the
supplied speakers.
- Do not connect more than one speaker to any
one pair of “f/ s p e a k e r terminals.
- Do not connect speakers with an impedance
lower than the speakers supplied. Please re^r to
the SPECIFICATIONS section of this manual
Optional Connections
The optional equipment and connecting conJs
are not supplied. Refer to the operating
instructions of the connected equipment for
details.
Line Out Connection
Connect this output to any analog audio
equipment for playback or recording (CD
recorder, tape recorder or amplifier for example).
Use a cinch cable to connect the LiNE OUT
terminals to the analog audio in terminals of the
equipment
Connecting other equipment to your
system
Connect the audio left and right OUT terminals
of a TV, VCR Laser Disc player DVD player or
CD Recorder to the AUX/CDR IN terminals.
Notes;
- Do not connect equipment to both the LINE
OUT andAUXICDR IN terminals at the same time.
Otherwise, noise wi№ be generated and malfunction
might occur.
- If you are connecting equipment with a
monaumi output (a single audio out terminal),
connect it to the AUX/CDR IN left temtinaL
Akematively.you can use a “single to double“ dnch
cable (still be mono sound).
Subwoofer Out Connection
Connect the subwoofer to the SUBWOOFER
OUT terminal. The subwoofer reproduces just
the low bass sound effect (explosions or the
rumble of spaceships, for example).
Digital Out Connection
Connect this digital output when recording on
any audio equipment with digital input (CD
Recorder, Digital Audio Tape [DAT] deck. Digital
to Analog Converter and Digital Signal Processor,
for example). Use a cinch cable to connect the
DIGITAL OUT terminal to the digital input
terminal of the equipment
Inserting batteries into the
Remote Control
Insert two batteries
(Type R06 or AA) into
the remote control with|'
the correct polarity as
indicated by the + and |
- symbols inside the
battery compartment
CAUTION!
- Remove batteries if they are exhausted
or not to be used for a long time.
- Do not use oU and new or different
types of batteries In combination.
- Batteries contain chemical substances, so
dispose of them properly.
10