Philips FWC87037 - Manual (Page 25)

Clock/TImer
View Clock
The dock (if it is set) will be shown in Standby
mode.
To view the clock in any source mode
(CD or TUNER, for example)
• Press CLOCK/TIMER briefly (or CLOCK on
the remote control).
The clock will be displayed for a few seconds.
If the dock has not been set will be
displayed.
Note:
- When in Eco Power Standby mode, the clock will
not be displayed.
Clock Setting
The clock can be set in either 12-hour or
2'1-hour mode (DM 15 ■ DO” or ‘QD■ for
example)
1 Press CLOCK/TIMER twee.
2 Press PROG on the system repeatedly to select
clock mode.
If 12-hour mode is selected, W1 It?-00" will
start flashing.
If 2‘1-hour mode is selected, "OD-00" will start
flashing.
3 Press or ►► on the system repeatedly to set
the hour.
4 Press M or M on the system repeatedly to set
the minute.
5 Press CLOCK/TIMER again to store the
setting.
The clock will start working.
To exit without storing the setting
• Press ■ on the system.
Nates:
- The clock setting will be cancelled when the
power cord is disconnected or if a power failure
occurs.
- When in Eco Power Standby mode, the clock!
timer function will not operate.
- During clock setting, if no button is pressed
within 90 seconds, the system will exit clock setting
mode automatkolly.
Timer Setting
The system can switch on to CD,TUNER, or
TAPE 2 mode automatically at a preset time,
serving as an alarm to wake you up.
IMPORTANTl
- Before setting the timer, ensure that the
clock Is set correctly.
- The timer will always be switched on
after It has been set.
- The timer will not start if a recording Is In
progress.
- The volume of the timer will Increase
gradually from the minimum level until It
reaches the last tuned volume level.
1 Press and hold CLOCK/TIMER for more than
two seconds to select timer mode.
-»DM 18^00'orDO'DO’orthe lasttimer
setting will start flashing.
-♦ TIMER will start flashing.
The selected source will be lighted while
other available sources are flashing.
25