Compaq HB1004 - Manual (Page 30)

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3-12 Setup and Configuration
Writer: Weldon W. Rowan Project: Setup and Configuration Comments:
File Name:SAB_3.DOC Last Saved On:7/2/98 4:53 PM
Assigning Trap Managers
Use the Trap Managers command from the Main Menu to modify current
values for the following parameters:
Figure 3-9. Trap Managers Screen
Q SNMP Community Names - The community strings authorized for trap
management access. All community strings used for IP Trap Managers
must be listed in this table.
‰ Community Name - A community entry authorized for trap
management access.
‰ Access Management - access is restricted to read-only (RO) or
read/write (RW).
‰ Status - The status of the current entry can be set to VALID or
INVALID.
Q IP Trap Managers - IP management stations selected to receive trap
messages from the HB1004 agent.
‰ IP Address - IP address of the management station.
‰ Community Name - The community string required for trap
management access.
‰ Status - The status of the current entry can be set to VALID or
INVALID.