Compaq HB1004 - Manual (Page 16)

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2-6 Installation
Writer: Weldon W. Rowan Project: Installation Comments:
File Name:SAB_2.DOC Last Saved On:7/2/98 8:49 AM
Diagnostic Tests
After power on, the hub automatically performs a diagnostic self-test. During
this test, port status LEDs indicate the success or failure of each test.
The system tests each component one at a time. At the completion of the test, if
no diagnostic LEDs are lit, then all components passed the test. If a component
fails the test, the corresponding LED will continue blinking. The following
table identifies the component that corresponds to each diagnostic test LED.
Figure 2-5 Power On Self Test Diagnostic LEDs
Table 2-1
LED Diagnostic Test Functions
LED Series LED Number Test Function/Component
Partition/Disable 1 CPU
2 Flash ROM 1
3 SRAM
4 LAN Controller
Link/Activity 1 HUB Controller
2 Serial Port RS232 Controller
3 EEPROM
4 Flash ROM 2