Cisco CRS-1 - Manual (Page 63)

B-3
Book TCisco CRS Carrier Routing System 8-Slot Line Card Chassis Site Planning Guideitle
OL-5802-09
Appendix B Product IDs for the Cisco CRS 8-Slot Line Card Chassis
Optional MSC, FP, PLIM, SIP, and SPA Product IDs
Optional MSC, FP, PLIM, SIP, and SPA Product IDs
Table B-2 and Table B-3 list the product IDs for the modular services cards (MSCs) and physical layer
interface modules (PLIMs) available for the Cisco CRS 8-slot LCC.
Route processor
(RP) 3
CRS-8-RP(=) Cisco CRS RP card
(one required for each chassis;
for redundant operation, you also need CRS-8-RP/R=)
Route processor, redundant CRS-8-RP/R(=) Optional route processor for redundant RP operation
(one required for each chassis, along with CRS-8-RP=)
Route processor memory CRS-MEM-2G(=)
CRS-MEM-4G(=)
RP memory module, 2 gigabytes
RP memory module, 4 gigabytes
Route processor blank CRS-8-RP-BLANK(=) Blank card carrier for each route processor slot
(used during shipment, must be replaced by a route processor
card)
Performance route processor
(PRP)
4
CRS-8-PRP-6G(=)
CRS-8-PRP-12G(=)
Cisco CRS performance route processor card
Route processor handle CRS-8-RP-HANDLE(=) Handle for carrying card (spare)
1. PEM = power entry module
2. PM = power module
3. RP = route processor
4. PRP = performance route processor
Table B-1 8-Slot Routing System Component Product IDs (continued)
Component Product ID Description
Table B-2 MSC Component Product IDs
Component Product ID Description
MSC 1
FP card
1. Refer to the product data sheet for ordering details.
CRS-MSC-B(=),
CRS-MSC-140G(=)
FP40
FP-140
Cisco CRS Layer 3 modular service card
(every MSC must have an associated PLIM)
Cisco CRS Layer 3 forwarding processor
(every FP must have an associated PLIM)
MSC impedance carrier CRS-MSC-IMPEDANCE(=) Blank card carrier for each empty MSC slot
(required for EMI compliance and cooling)