Cisco CRS-1 - Manual (Page 53)

4-5
Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Site Planning Guide
OL-5802-09
Chapter 4 Site Planning Considerations
Aisle Spacing and Maintenance Access Floor Plan
Figure 4-2 Typical Cisco CRS 8-Slot Line Card Chassis Floor Plan
Dimensions of the 8-Slot Line Card Chassis
The dimensions for the Cisco CRS 8-slot LCC are:
• Chassis depth (including front grille and optional front cover): 40.5 in. (102.9 cm)
• Chassis height: 38.5 in. (97.8 cm)
• Chassis width: 17.5 in. (44.5 cm).
Front and Rear Clearances
The site requires the following front and rear clearances for chassis installation and maintenance access:
• To install the chassis in the equipment rack: approximately 40 inches (101.6cm)
• To service components and allow system airflow (both in front of and behind the chassis): 36 inches
(91.4 cm)
Note Maintain at least 6 inches (15.2 cm) of clearance at both the inlet and exhaust openings on the
chassis and on the power modules to allow sufficient airflow.
122051
Service access
area: in front
of chassis
Service access
area: behind rear
of chassis
Cisco CRS 8-slot
line card chassis
112.5 in.
(285.67 cm)
40.5 in.
(102.87 cm)
36 in.
(91.4 cm)
36 in.
(91.4 cm)