Local management, 1 overview, Chapter 5 – Cabletron Systems 2E42-27 User Manual
Page 53: Overview -1, Refer to, For information on how to, Er to, Chapter 5 local management
2E42-27/2E42-27R/2E43-27/2E43-27R User’s Guide
5-1
CHAPTER 5
LOCAL MANAGEMENT
This chapter explains how to set up a management terminal to access
Local Management. It also explains how to use the Local Management
screens and commands.
5.1
OVERVIEW
Local Management for the 2E4X-27 consists of a series of management
screens that allow the management of the 2E4X-27 and its attached
segments. The management screens allow the user to do the following
tasks:
•
Assign IP address and subnet mask
•
Select a default gateway
•
Control access by establishing community names
•
Download a new image of the operation software
•
Designate which Network Management Workstations receive SNMP
traps from the device
•
View switch, interface and RMON statistics
•
Configure ports to operate in standard or full duplex mode
•
Trunking of ports to perform load sharing
•
Set the switch operation mode 802.1D, 802.1Q, or SecureFast VLAN)
•
Control the number of receive broadcasts that are switched out to the
other interfaces
There are three ways to access Local Management:
•
Locally using a VT type terminal connected to the COM port
•
Remotely using a VT type terminal connected through a modem
•
In-band through a Telnet connection