OmniSistem PR Solo 1200 - Manual (Page 4)

SOLO 1200 EN.doc 4/18
SAFETY CORD
(2PCS)
(2PCS)
CLAMPS
HANDLES
(2PCS)
(2PCS PER CLAMP)
RETAINERS
PASSING THROUGH
SAFETY CORD
4 HOLES FOR
To pass 2 SA FETY CORDS
t hrough 4 HOLES for safety! W ARNING
To pass 2 SAFETY CORDS
through 4 HOLES for safety!
WARNING
HOLE
SAFETY
CORD
106
25
6
HOLE
SAFETY CORD
Take 2 clamps and 2 safety cords out from the package and mount 2 clamps on the underside of
fixture with 2 retainers attached to each clamp. Hang the fixture on the structure and fasten the screws
attached to each clamp. (Watch the WARNING on the underside of the base as shown above) To
pass 2 SAFETY CORDS through 4 HOLES for safety! Always ensure that the projector is firmly
anchored to avoid vibration and slipping whilst functioning. Always ensure that the structure that you
are going to mount the projector is secure and is strong enough to support a weight of SOLO 1200.
WARNING: 1. Unlock the PAN and TILT before the 1
st
application of projector for safety.
2. The projector MUST be lifted or carried by the HANDLES instead of clamps.
TILT LOCK
2 NUTS 2 SPRING PLATES
BULB PST
Lock tilt before fitting/replacing the lamp.
Loosen 2 M5 screws of the back cover and open it, (You can see as shown in the right figure)
Loosen 2 lamp holder screws and take out the worn-out lamp.
Fit a new lamp then fasten 2 lampholder screws.
Notes: don’t touch the bulb of the new lamp with bare hand so as not to influence the beam
output.
WARNING: The MSR series are high-pressure lamps with external igniters (
). Care should
always be taken when handling these lamps. Always read the manufacturers "Instructions for
use" enclosed with the lamp.
FITTING THE LAMP
INSTALLING THE PROJECTOR