OmniSistem PR Solo 1200 - Manual (Page 14)

SOLO 1200 EN.doc 14/18
PROBLEM POSSIBLE CAUSE ACTION
The projector doesn’t switch
on
-The power supply is not
present
-The lamp doesn’t work Check the fuse on the power
socket.
Replace the lamp.
The lamp comes on but the
projector doesn’t respond to
the controller -Wrong DMX configuration
and/or start address
- Defective DMX cable Make sure that the projector is
correctly configured.
Replace or repair the DMX cable.
The projector only functions
intermittently
-The fan has failed
Make sure the fan is working and
not dirty.
Defective projection
-The lens is broken
-Dust or grease on lenses
Check the lenses are not broken.
Remove dust or grease from the
lenses.
The projected image
appears to have a halo
-Installation of the lamp is not
correct
-Dust or grease contamination
on the optics.
Make sure the lamp is installed
correctly.
Carefully clean the optical group
lenses and the projector
components.
The beam appears dim
-Dust or grease contamination
on the optics.
-The lamp is at the end of its
life Check the optics is clean.
Replace with a new lamp of the
specified type and rating.
LIGHT OUTPUT
16°
（
lux
）
5m
0
0
0
DISTANCE (m)
16° DIAMETER (m)
4m
2.00
5
1.41
8625
11980
16°
22.6°
22.6° DIAMETER (m)
480
345
7.05
10.0
25
540 2156 950
1330 2995 750
20
8.00
6.64
10
4.00
2.82
6.00
15
4.23
22.6°
（
lux
）
5m
1m
3m
1m
3m
4m
0m
2m
2m
TROUBLESHOOTING