OmniSistem PR Solo 1200 - Manual (Page 13)

SOLO 1200 EN.doc 13/18
right operation is: turn it off---cool down---push the slide bar to turn it on.
Green: ON
——DMX signal OK or Slave;
OFF
——No DMX signal;
Flash
——DMX signal error;
Red: Flash medium
——Setting menu mode ;
Flash fast
——Software or CPU fault ;
If the projector’s lens becomes damaged or broken it should be replaced. If the lamp becomes
damaged or deformed in any way it must be replaced. If the light from the lamp appears dim this
would normally indicate that it is reaching the end of its life and it should be changed at once, aged
lamps run to the extremity of their life might explode. If the projector does not function, check the
fuses on the power socket of the projector, they should only be replaced by fuses of the same
specification. Should these be damaged call a qualified technician before replacement. The projector
has thermal protection device that will switch off the projector in case of overheating, should either of
these operation, check that the fans are not blocked, and if they are dirty clean them before switching
on the projector again. Check that the fans are operational, if not call a qualified technician.
Any maintenance work should only be carried out by qualified technicians.
To ensure the continuous rotation of the rotating gobos and linear motion of the lens for focusing, it is
recommended that the bearings for the rotating gobos and the 3 shafts for the focusing lens holder be
lubricated periodically, preferably every two months. Use only high quality, high-temperature resistant
grease instead of any type of oil. When lubricating the bearings, a syringe with a fine needle is the
easiest way to introduce the grease to the bearings around each gobo.
To ensure the reliability of the projector it should be kept clean. It is recommended that the fans
should be cleaned every 15 days. The lens and dichroic colour filters should also be regularly cleaned
to maintain an optimum light output.
Do NOT use any type of solvent on dichroic colour filters.
Cleaning frequency depends on the environment in which the fixture operates: damp, smoke or
particularly dirty surroundings can cause greater accumulation of dirt on the unit’s optics. A soft cloth
and typical glass cleaning products should be used in cleaning. It is recommended to clean the
external optics at least once every 20 days and clean the internal optics at least once every 30 / 60
days.
Do not use any organic solvent, e.g. alcohol, to clean the reflector mirror, dichroic colour filters
or housing of the apparatus.
MAINTENANCE
KEEPING THE PROJECTOR CLEAN
LUBRICATION
LED INDICATION