OFM T42RD - Manual

A
Table Top
1 Unit
B
Large Leg
1 Unit
C
Small Leg
2 Units
E
Leveling Glide
4 Units
F
6x16mm Screw
40 Units
Assembly Notes:
During assembly, hand tighten screws only. When all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this table as a step ladder.
2. Check for loose screws and tighten them every 6 months.
Model T42RD
42” Round Meeting Table
Parts Listing
919-362-4765 (fax)
www.ofminc.com
161 Tradition Trail Holly Springs, NC, 27540
800-520-7471 (voice)
919- 303-6389 (voice)
[email protected]
02.13.2012
STOP
Assembly Instructions
Tools Needed: Phillips Head Screwdriver
Please read all instructions before assembly.
Step 1a: Place Table Top (A) face-down on carpet or padded work surface.
Note direction of grain on woodgrain models. “B” sticker,
indicating underside, should be facing up.
Step 1b: Attach Large Leg (B) to the center of the Table Top (A) by aligning
the holes and inserting Screws (F) through the L-Brackets (D) and
into the Top and the Leg as shown. Only hand tighten screws.
Step 2: Attach 1 Small Leg (C) by aligning perpindicularly with the center of
the Large Leg (B) as shown, and inserting Screws (F) through the
L-Brackets (D) and into the Top and Legs. Only hand tighten screws.
Step 3: Repeat Step 2 for the second Small Leg (C) on the opposite side of
the Large Leg (B). Once all screws are hand installed then securely
tighten all screws. Insert Leveling Glides (E) into the base of all Legs.
1
B
A
D
F
2
Leg 1
F
B
C
A
F
D
3
Leg 1
E
F
B
C
A
F
D
D
L-Brackets
10 Units