beautypg.com

OFM 610 User Manual

Model 610, Mesh “airflo” task chair, Assembly instructions

background image

A

Chair Back

1 Unit

B

Chair Seat

1 Unit

C

Chair Base

1 Unit

D

Casters

5 Units

E

Gas Lift

1 Unit

F

Telescopic Bellows

1 Unit

G

Seat Mechanism

1 Unit

H

Chair Arms

2 Units

I

8x30mm Screw

14 Units

J

Toothed Washer

14 Units

K

Washer

4 Units

L

Plastic Spacer

2 Units

Assembly Notes:

During assembly, hand tighten screw only when all screws

are in place, you may then tighten all screws completely.
CAUTION:

1. Do not use this chair as a step ladder.

2. Check for loose screws and tighten them every 6 months.

Model 610

Mesh “AirFlo” Task Chair

WEIGHT CAPACITY: 250 lbs.

Parts Listing

STOP

Assembly Instructions

Tools Needed: Phillips Head Screwdriver

Please read all instructions before assembly.
Step 1: Insert Casters (D) into Chair Base (C).
Step 2: Insert Gas Lift (E) into the hole in the center of the

Chair Base (C) and cover with Telescopic Bellows (F).

Step3: Place Chair Seat (B) upside-down on a level, non-

abrasive surface. Place two Plastic Spacers (L) on the

back two mechanism holes in the Chair Seat (B).

Step 4: Place Seat Mechanism (G) on Chair Seat (B) and align the

holes in the mechanism with the holes in the Chair Seat (B).

The back two holes in the Mechanism (G) should also line

up, and sit on top of, the holes in the Plastic Spacers (L).

Step 5: Place one Toothed Washer (J) and one Washer (K) on

each of four 8x30mm Screws (I) in order as shown. Insert

these screws through the holes in the Seat Mechanism (G)

and into the Chair Seat (B). The back two screws should

also be inserted through the Plastic Spacers (L) as shown.

Step 6: Attach Chair Back (A) to Chair Seat (B) using Toothed

Washers (J) and 8x30mm Screws (I).

Step 7: Attach Chair Arms (H) to Chair Seat (B) using Toothed

Washers (J) and 8x30mm Screws (I).

Step 8: Carefully sit on chair to make sure the Gas Lift (E) is

properly inserted into the base. Operate the gas lift lever

on the Seat Mechanism (G) to be sure unit is working.

919-362-4765 (fax)
www.ofminc.com

161 Tradition Trail Holly Springs, NC, 27540
800-520-7471 (voice)
919- 303-6389 (voice)
[email protected]

06.15.2010

C

D

K

G

J

A

I

F

E

J

I

J

B

I

H

L