OFM 122-DK - Manual

Parts Listing
I
Chair Seat
1 Unit
H
Chair Back
1 Unit
L
Casters
5 Units
M
Seat Mechanism
1 Unit
J
Chair Base
1 Unit
K
Chair Arms
2 Units
A
Long Screws for Arms
6 Units
B
Short Screws for Mechanism
4 Units
C
Small Washer for Arms
6 Units
D
Large Washer for Mechanism
4 Units
F
Gas Lift
1 Unit
G
Telescopic Bellows
1 Unit
E
Seatback Bellows
1 Unit
Assembly Notes:
During assembly, hand tighten screws. Only when all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this chair as a step ladder.
2. Check for loose screws and tighten them every 6 months.
Models 122 / 122-DK
Computer Task Chair
WEIGHT CAPACITY: 250 lbs.
919-362-4765 (fax)
www.ofminc.com
161 Tradition Trail, Holly Springs, NC, 27540
800-520-7471 (voice)
919-303-6389 (voice)
[email protected]
09.17.2014
STOP Assembly Instructions
Tools Needed: Phillips Head Screwdriver
Please read all instructions before assembly.
Step 1: Insert Casters (L) into Chair Base (J).
If you are assembling a model with a DK Foot Ring please proceed
to subsequent pages for drafting kit assembly instructions.
Step 2: Insert Gas Lift (F) into Chair Base (J), and cover with
Telescopic Bellows (G).
Step 3: Place Chair Seat (I) upside down on flat surface, and
align holes in bottom of seat with four holes in Seat
Mechanism (M). Attach Seat Mechanism (M) using
Short Screws (B) and Large Washers (D).
Tighten with screwdriver.
Step 4: Attach Chair Arms (K) to Chair Seat (I) using
Long Screws (A) and Small Washers (C).
Tighten with screwdriver.
Step 5: Place Seatback Bellows (E) over attached bar on Chair
Back (H). Insert attached bar on Chair Back (H) into hole
in back of Seat Mechanism (M). Tighten the hand
tighten knob on the Seat Mechanism (M) until Chair
Back (H) is secure.
Step 6: Place Chair Seat (I) onto Chair Base (J) by inserting
top of Gas Lift (F) into the hole in the middle of the
Seat Mechanism (M). Push down on Chair Seat (I)
to secure to Chair Base (J).
L
J
F
G
A
C
I
M
D
B
H
E
K