OFM 590-L - Manual

A
Chair Back
1 Unit
B
Chair Seat
1 Unit
C
Seat Mechanism
1 Unit
D
Chair Arms
2 Units
E
Chair Base
1 Unit
F
Casters
1 Unit
M
Large Allen Wrench
1 Unit
N
Small Allen Wrench
1 Unit
G
Gas Lift
1 Unit
H
Large Washer
2 Units
I
Small Washer
13 Units
J
8x15mm Screw
3 Unit
K
6x25mm Screw
4 Units
L
Arm Screws
6 Units
Assembly Notes:
During assembly, hand tighten screw only when all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this chair as a step ladder.
2. Check for loose screws and tighten them every 6 months.
Model 590-F / 590-L
Ultimate Executive Fabric/Leather & Mesh Hi-Back Chair
WEIGHT CAPACITY: 250 lbs.
Parts Listing
STOP
Assembly Instructions
Tools Needed: Phillips Head Screwdriver
Please read all instructions before assembly.
Step 1: Insert Casters (F) into Chair Base (E). Insert Gas Lift (G) into Chair Base (G).
Step 2: Attach Chair Arms (D) to Chair Seat (B) by placing Large Washers (H) between the Chair
Seat (B) and the Chair Arms (D), aligned with the inside hole on arms. Then with one Small
Washer (I) on each Arm Screws (L), insert screws through the holes in the Chair Arms (D)
and into the Chair Seat (B).
Step 3: Attach Seat Mechanism (C) to Chair Seat (B) by inserting four 6x25mm Screws (K), and
Small Washers (I) through holes in the Seat Mechanism (C) and into the Chair Seat (B),
using Small Allen Wrench (N) provided.
Step 4: Insert mounting plate on Chair Back (A) into back of Seat Mechanism (C) and attach with
three 8x15mm Screws (J), using Large Allen Wrench (M) that is provided.
Step 5: Take entire chair frame and place Seat Mechanism (C) onto Gas Lift (G), and press down
firmly to secure.
919-362-4765 (fax)
www.ofminc.com
161 Tradition Trail Holly Springs, NC, 27540
800-520-7471 (voice)
919- 303-6389 (voice)
[email protected]
06.14.2010
M
J
I
A
C
B
G
E
F
K N
I
C
H
I
B
L
D