OFM 77360 - Manual

Assembly Notes:
During assembly, hand tighten screws only. When all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this desk as a step ladder.
2. Check for loose screws and tighten them every 6 months.
06.18.2014
4
F
1
I
H
A
B
B
D
3
E
H
H
G
2
A B
H
C
B
A
Assembly Instructions
Tools Needed: Phillips Head Screwdriver
Tools Supplied: Phillips Head Screw Bit
Please read all instructions before assembly. Assembly will require 2 people.
Be sure to remove the Pedestal drawers prior to installation.
Step 1: Attach Side Panels (B) to underside of Desk Top (A) by aligning screw hole
brackets with holes in Desk Top (A), and inserting 6x16mm Screws (H) to
secure. Tighten using Phillips Head Screw Bit (I) or screwdriver.
Step 2: Attach Privacy Panel (C) to underside of Desk Top (A) and to Side Panels (B)
by aligning screw holes in Privacy Panel (C) with holes in Desk Top (A) and
holes in Side Panels (B), and inserting 6x16mm Screws (H) to secure. Tighten
all screws using Phillips Head Screw Bit (I) or screwdriver.
Step 3: Attach Pedestals (D) to Side Panels (B) and Desk Top (A) by inserting
6x16mm Screws (H) through pedestal wall and into Side Panel (B) and
through screw holes in Desk Top (A). Tighten using Phillips Head Screw Bit (I)
or screwdriver. Cover exposed holes in Pedestal (D) with Screw Cap (G).
Attach Drawer Runners (E) for Center Drawer (F) to underside of Desk Top (A).
Tighten using Phillips Head Screw Bit (I) or screwdriver.
Step 4: Flip the desk right side up using at least two people. Insert the Center
Drawer (F) backwards, as shown, aligning it with the Drawer Runners (E).
Push Center Drawer (F) all the way in to secure.
Note: At this time you can insert drawers back into each Pedestal (D) and
push all the way in to secure.
Parts Listing
I
Phillips Head
Screw Bit
1 Unit
E
Drawer Runners
2 Units
H
6x16mm Screw
31 Units
F
Center Drawer
1 Unit
Model 77360
Executive Series Double Pedestal Panel End Desk
919-362-4765 (fax)
www.ofminc.com
161 Tradition Trail, Holly Springs, NC, 27540
800-520-7471 (voice)
919-303-6389 (voice)
[email protected]
G
Screw Cap
4 Units
C
Privacy Panel
1 Unit
A
Desk Top
1 Unit
B
Side Panel
2 Units
D
Pedestal
2 Units
STOP