OFM 66366 User Manual
Mesa series single pedestal desk, Assembly instructions
H
10x35mm Screw
4 Units
B
Side Panel Legs
2 Units
C
Pedestal
1 Unit
D
Privacy Panel
1 Unit
F
Drawer
1 Unit
J
Allen Wrench
1 Unit
L
Corner
Leg Bracket
4 Units
G
6x55mm Screw
4 Units
I
6x16mm Screw
12 Units
Assembly Notes:
During assembly, hand tighten screws only. When all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this desk as a step ladder.
2. Check for loose screws and tighten them every 6 months.
Model 66366
Mesa Series Single Pedestal Desk
Parts Listing
919-362-4765 (fax)
www.ofminc.com
161 Tradition Trail, Holly Springs, NC, 27540
800-520-7471 (voice)
919-303-6389 (voice)
[email protected]
01.16.2014
STOP
Assembly Instructions
Tools Needed: Phillips Head Screwdriver
Please read all instructions before assembly. Assembly will require 2 people.
The following instructions result in a 66366L-ready desk. For a 66366R, please
assemble Pedestal on opposite side.
Step 1: Align Side Panel Legs (B) with the support rail on the underside of the Desk Top (A).
Place Corner Leg Bracket (L) in holes on support rail, and insert 10x35mm Screw (H)
through bracket and into legs. Tighten using Allen Wrench (J). Align Drawer
Runners (E) with holes in underside of the Desk Top (A). Attach using 6x16mm
Screws (I) and Phillips Head Screw Bit (K).
Step 2: Attach Pedestal (C) to underside of Desk Top (A) by aligning screw holes in
Pedestal with holes in Desk Top, and inserting 6x55mm Screws (G) to secure.
Tighten using Phillips Head Screw Bit (K) or screwdriver.
STOP
If you have Model 66366R or 66366L, please proceed to next
page for Return assembly.
Step 3: Attach Pedestal (C) to Side Panel Legs (B) by inserting
6x16mm Screws (I) through pedestal wall and into legs.
Tighten using Phillips Head Screw Bit (K) or screwdriver.
Step 4: Attach Privacy Panel (D) to Pedestal (C) by inserting 6x16mm
Screws (I) through side of Privacy Panel (D) and into the side of
Pedestal (C). Attach Privacy Panel (D) to Side Panel Legs (B)
by inserting 6x16mm Screws (I) through other side of Privacy
Panel (D) and into the corresponding hole on the inside of the
Side Panel Leg (B). Tighten using Phillips Head Screw Bit (K).
Step 5: Flip the desk right side up using at least two people. Insert the
Drawer (F) backwards, as shown, aligning it with the
Drawer Runners (E). Push Drawer (F) all the way in to secure.
A
Desk Top
1 Unit
E
Drawer Runners
2 Units
K
Phillips Head
Screw Bit
1 Unit
3
I
4
C
D
I
K
5
F
A
E
E
J
L
H
B
I
1
G
B
A
2
C