OFM 315 User Manual
Model 315, Assembly instructions, Ab c

919-362-4765 (fax)
www.ofminc.com
Ganging Brackets are standard on all
Model 315 Chairs
A
Chair Seat
1 Unit
B
Chair Base
1 Unit
C
Screw
4 Units
CAUTION:
1. Do not use this chair as a step ladder.
2. Check for loose screws and tighten them every 6 months.
Model 315
Stack Chair
Parts Listing
161 Tradition Trail, Holly Springs, NC, 27540
800-520-7471 (voice)
919- 303-6389 (voice)
[email protected]
01.09.2013
A
B
C
STOP
Assembly Instructions
Tools Needed: Phillips Head Screwdriver
Please read all instructions before assembly.
Step 1:
Place Chair Seat (A) upside down on the edge
of a hard surface. Place the Chair Base (B)
upside down on the Chair Seat (A) and align
the holes as shown.
Step 2:
Insert Screws (C) to secure Chair Seat (A).
Make sure Screws (C) are fully inserted and
secured.
- 247-VAM (2 pages)
- 810-LX (1 page)
- 811-LX (1 page)
- 710 (1 page)
- 800-L (1 page)
- 700 (2 pages)
- ORO200 (3 pages)
- 408-C (1 page)
- 404-C (1 page)
- 338C (1 page)
- 241-VAM-DK (3 pages)
- 910 (1 page)
- 650 (1 page)
- 610 (1 page)
- 902-VAM-DK (2 pages)
- 105 (3 pages)
- 122 (2 pages)
- E125 (2 pages)
- E336 (1 page)
- 921 (1 page)
- 611 (1 page)
- E1001 (1 page)
- 150 (3 pages)
- 200 (2 pages)
- 130 (3 pages)
- ORO300 (3 pages)
- ORO100 (3 pages)
- 581 (1 page)
- 580 (1 page)
- 640 (1 page)
- 118-2 (3 pages)
- 522-LX (1 page)
- 521-LX (2 pages)
- 119-VAM (3 pages)
- 654 (1 page)
- 606 (1 page)
- 550 (1 page)
- 453 (1 page)
- 590-F (1 page)
- 591-F (1 page)
- 670 (1 page)
- 660 (1 page)
- 655 (1 page)
- 560-L (1 page)
- 565-L (1 page)