OFM N202 User Manual
Model n202, Net 4-leg chair, Assembly instructions

A
Seat
1 Unit
B
Base
1 Unit
C
Plastic Cap
1 Unit
D
8x25mm Screw
4 Units
E
8mm Nut
4 Units
F
Allen Wrench
1 Unit
Assembly Notes:
During assembly, hand tighten screws only. When all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this chair as a step ladder.
2. Check for loose screws and tighten them every 6 months.
Model N202
NET 4-Leg Chair
WEIGHT CAPACITY: 300 lbs.
Parts Listing
919-362-4765 (fax)
www.ofminc.com
161 Tradition Trail, Holly Springs, NC, 27540
800-520-7471 (voice)
919- 303-6389 (voice)
[email protected]
05.16.2012
STOP
Assembly Instructions
Tools Needed: Adjustable Wrench and supplied Allen Wrench
Please read all instructions before assembly.
Step 1: Attach Base (B) to Seat (A) by aligning the
holes between the two. Now insert 8x25mm
Screws (D) under metal mesh of Seat (A) and
down through holes. Attach the 8mm Nuts (E)
on the bottom of 8x25mm Screws (D) using the
Allen Wrench (F). Tighten all screws securely only
when all four have been attached.
Step 2: Cover 8x25mm Screws (D) under mesh with
Plastic Cap (C).
B
E
A
C
D