OFM 822 - Manual

Model 822
InterPlay Sofa
Parts Listing
C
Tablet Support Bar
2 Units
D
6x12mm Tablet Screw
6 Units
F
Wrench
1 Unit
G
Allen Wrench
1 Unit
Assembly Notes:
During assembly, hand tighten screws only. When all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this sofa as a step ladder.
2. Check for loose screws and tighten them every 6 months.
WEIGHT CAPACITY: 500 lbs.
919-362-4765 (fax)
www.ofminc.com
161 Tradition Trail
.
Holly Springs, NC, 27540
800-520-7471 (voice)
.
919-303-6389 (voice)
.
[email protected]
02.11.2014
E
Caster
2 Units
Assembly Instructions
Tools Needed: Allen Wrench and
Wrench (provided).
Step 1: Attach the Casters (E) to the Sofa (A)
by carefully laying theSofa (A) onto
its back and screwing the Casters (E)
into the corresponding holes on the
bottom of the Sofa frame and tighten
using the provided Wrench (F).
Step 2: Return Sofa (A) to upright position.
Step 3: Attach Tablet Support Bar (C) to
Tablet (B) by inserting 6x12mm
Tablet Screws (D) through the holes
and into the bottom of the Tablet (B)
using Allen Wrench (G).
Step 4: Insert Tablet Support Bar (C) into
the Sofa (A), being careful to line up
notch on the bottom of the bar with
inset gap in the sofa grommet hole.
Be careful to place the tablets on the
appropriate sides of the Sofa (A).
Both tablets should face inward
toward to Sofa as shown..
B
Tablet
2 Units
Right Tablet
Left Tablet
STOP
A
Sofa
1 Unit
B
A
E
E
E
E
D
C
B
Wooden feet to
match tablet.
NOTE: The optional wooden Feet
should be screwed into
the rear of the Sofa frame
to be most effective.