Oberon 33-WAP-SKIN - Manual (Page 2)

1
Installation Instructions
Cisco Skins
Rev 4/13/12 Oberon, Inc. •••• 1315 S. Allen Street •••• State College, PA 16801 Copyright 2012
Figure 1: Cisco 1140/3500 AP Figure 2: Oberon Skin
The following procedure should be used to install the Oberon skin on the Cisco 1140/3500 access
point.
1) Be sure that the surfaces of the Cisco AP and the skin are clean. Prepare both surfaces by
wiping with an alcohol swab to remove dirt and oil.
2) Remove the protective covering to expose the adhesive on the Velcro strips and place one
piece on each side the plastic dome of the Cisco Access Point near the metal center section
as shown in Figure 1.
3) Repeat the procedure for the dome, placing the Velcro strips just outside of the raised emboss
inside the skin as shown in Figure 2.
4) Place the skin onto the Cisco AP and press firmly to lock the Velcro strips together. Note that
the Velcro strips have significant holding power and removing the cover will be very difficult.