Oberon 1057-00 - Manual

Installation Instructions
Model Number 1057-00
(877) 867-2312 • www.oberonwireless.com
Rev. 3B 06/05/14 Oberon, Inc. •••• 1315 South Allen Street •••• State College, PA 16801 Copyright 2013
Figure 4 - View showing enclosure installed in ceiling grid.
Assembly Components:
- Ceiling enclosure Model 1057-00 assembly – 1 each
- #10-32 Screws – 4 each
- 1” Trade Size Cable Clamp – 1 each
- Keys for access door lock – 2 each
- Support wire – 4 each
- Firestop Grommet – 1 each
If any of these items are missing,
contact your Oberon representative.
Find a flat work surface to assemble
the ceiling enclosure, access point
and antenna(s) prior to mounting in
ceiling.
Step 1 – Place the ceiling enclosure
assembly on the work surface with
the keyed doorway unlocked. The
eye tabs located on each corner will
be used to secure the enclosure
with grid wires (Ref. Figure 1).
Depending on the installation, the
grid wire can be attached now, or
you can wait until it has been
installed in the ceiling to attach the
grid wires
Step 2 – Install the conduit
connector. Remove the knockout(s)
from the inside of the enclosure.
Insert the cable clamp through the
hole with the nut installed from the
inside of the enclosure. If using
Power Over Ethernet (P.O.E.) use 1
cable clamp. If P.O.E. is not being
used, install both cable clamps and
bring power and Ethernet into the
enclosure through separate clamps
(Ref. Figure 2).
Page 2
Step 3 – (Any manufacturer’s access
points) Install the access point’s mounting
plate to the enclosure’s “T-Bar” bracket
using the manufacturer’s instructions for
attaching the mounting bracket to a ceiling
tile grid (T-Bar). Attach the Access Point to
the mounting plate. (Ref. Figure 3).
Step 4 – Remove the ceiling tile and replace
it with the completed access point enclosure
assembly.
Step 5 – Use minimum 12-gauge grid wire to
secure the access point enclosure in the
ceiling grid. Attach one end of the wire to the
eyebolts and the other end to a permanent
structure within the ceiling such as a ceiling
joist (Ref. Figure 4).
**IMPORTANT** - This is an important
safety feature that could prevent human
injury or damage to the access point,
should the unit become dislodged from
the ceiling grid.
Step 6 – Run the data and power cable (if
required) through the conduit connectors
located on sides of the access point
enclosure. In order to maintain a separation
of signal and power, install the data and
power cables through opposite sides of the
enclosure utilizing the two knock-outs
provided. Pull the data cable through the
conduit connector far enough to allow
attachment to the access point (8" - 10").
Snap the grommet on to the cable and slide
it inside the conduit connector.
Step 7 – Attach data and power cables to
the access point through the access door
then tighten the screws on the cable clamp.
Step 8 – Close and lock the access door.
The installation is now completed.
Page 3
Figure 1
Figure 2 – Installation of cable clamp(s)
Figure 3 – Install Access Point in enclosure.