Oberon 1075-CP - Manual

Installation Instructions
Model Number 1075-CP
(877) 867-2312 • www.oberonwireless.com
Rev. A2 05/23/13 Oberon, Inc. •••• 1315 South Allen Street •••• State College, PA 16801 Copyright 2013
Figure 5 – Exploded door view.
Assembly Components:
- Ceiling enclosure Model 1075-CP assembly – 1 each
- Ceiling tile bridge – 2 each
- #8-32 X 1/4 “ screw –4 each
- #8-32 nut – 4 each
- 3/4” Trade Size Cable Clamp – 1 each
- Keys for access door lock – 2 each
- Support wire – 4 each
- Fire Block Foam – 1 each
If any of these items are missing, contact your Oberon representative.
Find a flat work surface to assemble the ceiling
enclosure, access point and antenna(s) prior to
mounting in ceiling.
Step 1 - Cut a 13” x 13” opening in the center of a
ceiling tile (not included – ref. Figure 1).
Step 2 – Place the ceiling enclosure assembly on the
work surface. Remove one of the 1” trade size hole
cover on the side of the enclosure and install the 1”
conduit nipple (the side on which the conduit nipple is
to be installed will be determined by the location the
enclosure is to be installed and direction from which
conduit will be brought into the enclosure – ref. Figure
2).
Page 2
Step 3 –Lay ceiling tile over the
enclosure assembly such that
the previously cut opening in the
ceiling tile is equally spaced
around the outside of the
enclosure (ref. Figure 3). Place
the ceiling tile bridges along
each side of the enclosure and
attach using a #8-32 screw.
Prior to tightening, be sure to
properly align the tile bridges so
the ends of the tile bridges align
with the outside edge of the
ceiling tile. Once the tile bridges
are properly aligned, press the
shoulder of the tile bridge down
firmly against the tile and then
securely tighten the screws.
This is to assure that there is
minimal
gap between the
enclosure’s flange and the
ceiling tile once it is placed in
the ceiling. The four (4) holes on
the tile bridge will be used to
secure the enclosure with grid
wires.
Step 4 – Unlock and open the door. Use the
manufacturers T-Bar mount clip to attach the access point
to the T-Bar Section on the mounting plate. An additional
mounting plate provided by the manufacturer of the access
point may be needed to attach the access point (Figure 5).
Data cable(s) may need to be plugged in to the access
point prior to attaching to the mount. Cisco access points
use Cisco AIR-AP-BRACKET-2 for 2600/3600 series
access points and AIR-AP-BRACKET-1 for 1140/3500
series.
Page 3
Figure 2 - Hardware installation.
Figure 3 - Installation to ceiling tile.
This product is Listed by Underwriters
Laboratories Inc. Representative
samples of this product have been
evaluated by UL and meet applicable
safety standards.
File #E348543