Oberon 33-AHAP330-SKIN - Manual (Page 2)

Installation Instructions
AHAP330 Skin
Rev 04/04/14 Oberon, Inc.
•
1315 S. Allen Street
•
State College, PA 16801 Copyright 2014
Figure 1: Aerohive AP330 Figure 2: Oberon Skin
The following procedure should be used to install the Oberon skin on the Aerohive Networks AP330
access point.
1) Be sure that the surfaces of the Aerohive AP and the skin are clean. Prepare both surfaces by
wiping with an alcohol swab to remove dirt and oil.
2) Remove the protective covering to expose the adhesive on the Velcro strips and place one
piece on each side the plastic dome of the Aerohive Access Point near the metal center
section as shown in Figure 1.
3) Repeat the procedure for the dome, placing the Velcro strips just outside of the raised emboss
inside the skin as shown in Figure 2.
4) Place the skin onto the Aerohive AP and press firmly to lock the Velcro strips together. Note
that the Velcro strips have significant holding power and removing the cover will be very
difficult.