Oberon 38-52-ENT3610 - Manual

Installation Instructions
Model Number 38-52-ENT3610
Assembly Components:
- Door Assembly – 1 each
- #8 - 32 screw – 3 each
(877) 867-2312
 www.oberonwireless.com
Rev. 7/25/11 Oberon, Inc.
 1315 South Allen Street  State College, PA 16801
Copyright 2011
- #8 – 32 hex nuts – 4 each
If any of these items are missing, contact your Oberon representative.
Find a flat work surface to assemble the mounting plate, access point, and door.
Step 1 – Attach the Enterasys
mounting plate to the Oberon
mounting plate using three (3) #8-32
screws (Ref. Figure 1).
Step 2 – Attach the Enterasys 3610
Access Point to the Enterasys mounting
plate by placing it over the Enterasys
mounting plate and sliding it into the
locking position (Ref. Figure 2).
Page 2
Figure 3
Figure 1
Figure 2
Final Assembly
Step 3 – The door assembly is completed by attaching the previously assembled mounting plate/access point assembly to the
enclosure door by securing it in place with four (4) #8-32 hex nuts. Place the slotted holes in the mounting plate/access point
assembly over the studs located on the bottom side of the door (NOTE: the mounting plate can only be attached to the door in
one direction. If the slotted holes don’t match up with the studs in the door, rotate the mounting plate 180°). Once the
mounting plate is positioned, secure it in place by installing four (4) #8-32 hex nuts. (Ref. Figure 3).
Step 4 – Install the completed door assembly in the enclosure by removing the current door (if not previously done) and
replacing it with the door assembly. To remove the old door, open the enclosure and remove the three (3) hex nuts holding
the door in place. Install the door assembly by placing the three (3) mounting holes in the door over the studs on the hinge
and then replace the nuts.
Page 3