NORAC UC5-BC-ECHO-VT - Manual (Page 35)

31
9.2 Safe Mode
This option is only available when the system is set up as an Active Roll type. The purpose of
Safe Mode is to provide basic functionality in the event that a sensor or hydraulic component
required for the Active Roll functionality becomes damaged. Enabling Safe Mode will allow the
sprayer to continue functioning with the UC5 height control, but it will not function to the full
Active Roll level. This feature should only be used if there are problems with the Active Roll.
9.3 Headland Assist
Selecting this option will enable Headland Assist. By default, this feature is enabled for certain
sprayer types. Headland Assist is used to raise the wings only or the entire boom at the end of
the field for turning. This feature operates when the system is in Automatic Mode.
The headland mode height can be changed. While the boom is in headland mode, the operator
can change the height by simply adjusting the target height.
When the check box is checked to enable this option, the Headland Mode and Headland
Trigger Menu will be displayed.
Figure 20: Headland Mode and Headland Trigger
9.3.1. Headland Mode
The Headland Assist feature can operate in two different modes; Main or Wings Only.
If the Main Mode is selected, when the Headland Assist is triggered the wings will temporarily
be disabled and the main lift will raise to the predetermined Headland Assist height to allow the
operator to turn around at the end of the field. When triggered again, the entire boom will
return to Automatic Mode.
If the Wings Only mode is selected, when the Headland Assist is triggered only the wings will
raise to the Headland Assist height. When triggered again, the entire boom will return to
Automatic Mode.
9.3.2. Headland Trigger
When the Headland Assist feature is enabled, a trigger type must be selected to activate it in
the field. The trigger may be either the Main Lift up/ down switch or the Remote Auto input
line.