NORAC UC5-BC-ECHO-VT - Manual (Page 28)

24
Once the sensor serial numbers and locations are known, the sensor setup can be performed
using the following steps:
Navigate to the Sensors screen by selecting the
Sensor Setup button as shown in Figure 16.
To add a sensor to a boom location, select the
sensor location where you want to add the
sensor.
Select the appropriate serial number from the
selection box.
Continue this for each of the sensors, if
necessary.
To set the sensor height, select the appropriate
sensor location. Measure from the ground to
the bottom of the nearest sprayer nozzle tip.
Select the nozzle height textbox and enter the
measured number.
To add a roll sensor, select the Roll Sensor
button.
To add a roll sensor or a position sensor to a
boom location, select the sensor location where
you want to add the sensor.
For the roll sensors, the text will show
Measured Roll. This should be near zero when
the boom is level.
For the position sensors, the text will show the
measured distance. This should be near zero
when the boom is level.