NORAC UC5-BC-HG03 - Manual (Page 26)

23
6. Remove the plug from the Sense Line Bleed port. Location is shown in Figure 23. Gently
tap the plug with a hammer to loosen it before attempting to remove it.
7. Remove the Sense Line Bleed Orifice and discard. Install the setscrew (M08) into the Sense
Line Bleed Orifice location. Ensure the setscrew is threaded entirely into the hole and
tightened to 35-40 in-lbs to ensure a tight seal. Reinstall the plug and tighten to 35-40 in-
lbs.
Figure 23: Load Sense Bleed Orifice Location on Top of Block