NORAC UC5-BC-HG03 - Manual (Page 23)

20
8.3 Input Module
1. Install the input module (E03) on the boom near the sprayer valve block.
2. Connect the free end of the CANbus cable (C02) from the valve module to the input
module. Connect cable C05 to the other CANbus connector and route to the 8-way
coupler.
3. Insert the 12-pin plug (P02) into the OEM 3 connector on the end of the input module
4. Connect the 12-pin connectors on the interface cable (C20) to the Thru 2 connector and
the Thru 1 connector on the sides of the input module.
Figure 20: Input Module Connections
5. Connect the 12-pin receptacle on C20 to the Hagie interface connection.