NORAC UC5-BC-HG03 - Manual (Page 21)

18
Figure 18: Valve Module Bracket Installation
Figure 19: Valve Module - Valve Coil Connections
5. Connect cable C04 to the valve module CANbus connector. Route cable C02 from the
other CANbus connector to the input module.
6. With the valve module securely mounted to the valve block, connect the valve cables (C10),
to the valve coils. Insert the 2-pin plug (P01) into the unused 2-pin connectors on output 8.
7. Connect cables C11 to outputs 5 and 6 on the valve module. Route the cables C11 to the
Hagie valve block.
8. Connect cable C12 to output 7 on the valve module. Route cable C12 to the Hagie valve
block.
Tank Port
Pressure Port
Sense Port
Left Tilt Ports
Right Tilt Ports