NORAC UC5-BC-HD06 - Manual (Page 37)

34
10.5 Hydraulic Plumbing
From this point on in the installation the booms will be inoperative until the
hydraulics are fully installed.
1. After the valves are mounted on the sprayer, the hydraulic hoses and fittings can be
installed (plumbed).
2. Install tee fittings (HARDI01) on the “P”, “T” and “B” port fittings at the HARDI block.
3. Connect pressure and tank lines between the HARDI block and the NORAC block.
4. The wing tilt “raise” must be connected to the “B” ports of the NORAC block in parallel
with the existing HARDI valve block.
 Connect the “B” ports of the NORAC block to the wing raise lines by connecting
HARDI02 between the “B” ports and the tee fittings installed in the HARDI block.
5. The “A” ports on the NORAC block are plugged. The “lower” lines of the cylinders are to
remain attached to the HARDI sprayer valve block.