NORAC UC5-BC-HD06 - Manual (Page 25)

22
8 Module Installation
An optional module mounting bracket kit is available for purchase from NORAC. The
mounting brackets are compatible with control modules and input modules. One kit is needed
per module.
Item Part Number Name Quantity
B20 43708 UC5 MOUNTING BRACKET KIT (CONTROL AND INPUT MODULES) 1
8.1 Control Module
1. Refer to Figure 1 and Figure 19.
2. Securely mount the control module (E01) near the hitch of the sprayer within reach of the
display terminal connections, using screws, cable ties or optional brackets.
3. Connect the display terminal to the control module using the display CANbus cable. This
cable must be connected to the end of the control module with only one Deutsch
connector.
4. Route cable C02 from one of the control module CAN connectors towards the valve
block. This will connect to the valve module.
5. Route cable C01 from the other CANbus connector towards the DAH09 enclosure. This
will connect to the input module.
Figure 19: Control Module Mounting