NORAC UC5-BC-HD06 - Manual (Page 28)

25
8.3 Input Module
1. Install the input module (E03) on the boom near the enclosure that houses the HARDI
DAH09 PCB. Secure it to the boom using cable ties or optional brackets.
2. Connect the free end of the CANbus cable (C01) from the control module to the input
module.
3. Insert the 12 pin plug (P02) into the OEM 3 connector on the end of the input module.
4. Connect all 3 connectors of C20 to the input module.
Figure 24: Input Module Connections
5. Run the DB15 connector and the wires with the spade connectors of C12 to the DAH 09
PCB by passing it through a hole in the enclosure. Seal the hole using the weather-proof
strain relief fitting.
6. Connect the DB15 connector of cable C12 to the DAH09 DB15 connector.
7. Connect the red wire with spade connector on C12 to the Switched 12VCC on the
DAH09 board (Figure 25).
8. Connect the black wire with spade connector on C12 to the GND on the DAH09 board
(Figure 25).