NORAC UC4+BC+GV1 - Manual (Page 26)

24
Figure 29: Cable Configurations: C02, C02B, C03, C12 and C16
6. Route cable C11 to the rear of the
sprayer, near the sprayer valve block.
7. Attach the valve cable C03 to the 6 pin
shroud on cable C11.
8. Install the Deutsch connectors from
C03 onto each NORAC valve as shown
in Figure 30.
9. The connectors on the valve cable
(C03) are marked RIGHT UP, LEFT
UP, RIGHT DOWN and LEFT
DOWN. Cables labeled with UP go
on the same side as the hydraulic hoses
Figure 30: Valve Cable Connections
10. Connect T3 on cable C16 to the three
pin shroud on cable C11.