NORAC UC4+BC+GV1 - Manual (Page 17)

15
Figure 15: Roll Sensor Mounting with Respect to Sprayer Orientation
4.5.1 Boom Frame Roll Sensor
Mounting
The boom roll sensor (E04) must be
mounted to the rotating part of the boom.
Follow these guidelines and refer to Figure
14 and Figure 16 to mount the sensor.
a) Make sure you are using a roll sensor
that does NOT have a temperature
probe (only one cable) with the lowest
serial number (E04).
b) The boom roll sensor must be mounted
to the rotating part of the boom
suspension.
c) Use cable-ties to secure the bracket to
a square edge feature (square tube).
d) Ensure the AMP (circular) connector
exits towards the Right Hand Wing
(when looking from the rear of the
sprayer).
e) Securely cable-tie the connector to the
frame.
4.5.2 Intermediate Frame Roll Sensor
Mounting
The intermediate roll sensor must be
mounted to a non-rotating part of the
boom. To mount the chassis roll sensor,
follow the following guidelines and refer to
Figure 14 and Figure 16.
a) Make sure you are mounting the roll
sensor that does have a temperature
probe (2 cables) (E03).
b) Mount the intermediate roll sensor
(E03) to a non-rotating part of the
boom.
c) Cable-tie the bracket to a square edge
feature (square tube).
d) The AMP (circular) connector MUST
exit towards the Right Hand Wing
(when looking from the rear).
e) Make sure the temperature probe is
able to reach the side of the valve block.
f) Securely cable-tie the connector to the
frame.
* The boom frame and
chassis roll sensors do
not have temperature
probes