NORAC UC4+BC+GM1 - Manual (Page 15)

13
4.4 M
AIN
L
IFT
S
ENSOR
I
NSTALLATION
1. Assemble the main lift sensor bracket (B11)
as shown in Figure 10.
Figure 10: Main Lift Sensor Bracket
2. The bracket can then be mounted to the
lowest frame member on the center section
of the sprayer. The bracket should be
mounted so the sensor mounting collar is in
approximately the center of the sprayer and
ahead of the boom (Figure 11 and Figure
12).
The sensor mounting collar must not
be behind the sprayer’s wheel.
The General Mounting Rules for
UC4+ Ultrasonic Sensors, from the
previous section, must be followed.
Figure 11: Main Lift Sensor Bracket
Mounting Position
3. Mount the sensor onto the sensor mounting
collar (Figure 11).
Figure 12: Main Lift Sensor Mounted in
the Correct Location
Bracket Tube
Sensor
Mounting Tab
Sensor Mounting
Collar
Bracket Base