MUTEC MC-6 - Manual (Page 10)

\\\\\\\\\\\\\
C O N T R O L E L E M E N T S C O N T R O L E L E M E N T S C O N T R O L E L E M E N T S
> > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > >
> > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > 88
4 AES3 IN
This AES/EBU input can receive a balanced digital AES3 or AES11 signal in
compliance with AES3 –1992 (R1997) or AES11–1997/2003. The input imped-
ance is 110 Ω (XLR connector, female).
5 S/P-DIF IN
These two S/P-DIF inputs, available as optical (»OP«) and coaxial (»CO«)
interfaces, can receive an optical S/P-DIF and an unbalanced electrical S/P-DIF
digital audio or blank frame signal in compliance with the IEC 60958 stand-
ard. The coaxial interface impedance is 75 Ω. (cinch connector), the optical
interface offers a Toshiba Toslink
TM connector, EIAJ standard.
6 AES3id IN + WCLK IN
The first input above can receive an AES3id digital audio stereo signal in
compliance with the AES3id–2001 standard. The second input below can
receive a Word Clock so-called »Super Clock« (Word Clock x 256) signal. The
impedances of both connectors are 75 Ω (BNC connectors, female).
The termination of the WCLK input can be switched off. See page 28 for
details.
7 AES11 REF IN
This input receives a balanced digital AES11 blank frame signal in com-
pliance with AES11–1997/2003 as master clock reference for the SRCs.
Alternatively, an AES3 digital audio signal in compliance with AES3 –1992
(R1997) or a S/PDIF digital audio signal aligned to IEC60958 can be input as
well. The input impedance is 110 Ω (XLR connector, female).
8 MAINS IN, Power Switch + Power Inlet
This is the main switch for switching the device on and off. Be sure to
make all connections (especially the supplied power cable) properly before
turning on the switch. Heed the SAFETY INSTRUCTIONS at the beginning of
this manual.
Connect the supplied power cable here. Make sure that the power switch
is turned off before connecting the power cable to this inlet and to the
power outlet. Line voltages within the range of 90…260V with a frequen-
cies between 47...440Hz can be applied. The internal power supply will
automatically make all necessary adjustments.
10