Muchmore CTX D2 - Manual (Page 7)

8.PULSE DISCHARGE
E5
Discharged time is monitored by when your cell's voltage
is reached to the cut-off voltage
The CTX-D2 counts discharged time
only when your cells are 30A discharged.
3.PULSE DCH
4.ZERO VOLT
0.00 0.00 0.00
0.00 0.00 0.00
1.48 1.47 1.48
1.48 1.48 1.47
PDCH PDCH PDCH
PDCH PDCH PDCH
360 365 371
342 333 356
11 12 9
11 10 11
DONE DONE DONE
PULSE DCH DONE
00:00:03
Internal resistance.
Note: If you want to get exact IR numbers of your cells,
we recommend to discharge them when they are fully charged.
Low IR means the cell has good condition.(It has punch)
HIgher IR means the cell has bad condition.(Flat power)
PULSE DCH START
Each cell's voltage showing up.
Current voltage is displayed.
Once each cell's voltage is reached to the cut-off voltage, the
pulse discharge is done.
Elapsed time is displayed after Pulse discharge is done.
PDCH DONE PDCH
SEC
IR
Pulse discharge mode discharges your cells at
pulse 30Amp rate until the cut-off voltage is
reached.
You can get Discharged time(run time) and Internel
resistance(IR) out of this mode.
Tray your battery pack on the
CTX-D2. Make sure battery pack's
polarity and direction are correct.
Tighten 12screws tight in order
to get exact data.
Voltage
0.5sec 0.5 0.5 0.5 0.5
0.5 0.5 Counted (3.5sec)
at 30A discharge
not counted
Not counted
2.5 2.5 2.5 2.5 2.5
2.5
2.5sec
Time
Determine discharge
cut off voltage(0.20V~1.20V).
CUT OFF VOLT
0.90V 30A