Muchmore CTX D2 - Manual (Page 4)

4.MAIN MENU
3.HOW TO CONNECT BATTERIES
5.Error messages
MUCH-MORE RACING
CTX-D V2.0
E2
1.LINEAR DCH
2.DEAD SHORT
3.PULSE DCH
4.ZERO VOLT
5.LAST DATA LINEAR DCH SET UP
DEAD SHORT SET UP
Please see
There is no set up mode.
INSERT ERROR
REMOVE BATTERY
Remove your battery pack immediately
then check their direction and polarity.
Remove your battery pack immediately
then check their direction and polarity.
Or there may be some bad connection between
battery cells and terminals.
BATTERY ERROR
CHECK CONNECTION
6.LINEAR DCH
7.DEAD SHORT
8.PULSE DCH
9.ZERO VOLT
10.LAST DATA
The CTX-D2 has 17posts in total. 5posts are guidance to place your pack battery to proper polarity.
Guide posts
matching
data
5A linear dch.
30A pulse dch.
ext. port
dead short
accurate data
Place your cells as follows. Otherwise the CTX-D will show you error message.
matching
data
5A linear dch.
30A pulse dch.
ext. port
dead short
accurate data
matching
data
5A linear dch.
30A pulse dch.
ext. port
dead short
accurate data
matching
data
5A linear dch.
30A pulse dch.
ext. port
dead short
accurate data
1cell 2cells 3cells 4cells
matching
data
5A linear dch.
30A pulse dch.
ext. port
dead short
accurate data
matching
data
5A linear dch.
30A pulse dch.
ext. port
dead short
accurate data
matching
data
5A linear dch.
30A pulse dch.
ext. port
dead short
accurate data
5cells 6cells
You may hear "click" sound when you connect your batteries on CTX-D2. This means the protectection system working properly.
To get accurate data of your battery with D2, keep your batteries surface clean.
Do not touch any screws or posts during the CTX-D2 is discharging.
It may change discharging current or voltage reading value significantly.
Note: