Motion Pro 08-0411 - Manual

INSTRUCTIONS
Process Black
White White/Black MOTION PRO, INC. LOGO
Motion Pro, Inc.
867 American Street
San, Carlos, CA 94070
Tel: 650.594.9600 Fax: 650.594.9610
www.motionpro.com
Motion Pro ® 08-0411 SyncPRO™ Carb Tuner
Assembly
Thank you for purchasing the Motion Pro SyncPRO™ Carb Tuner. This is a precision instrument and in order to insure that it is setup and used
properly please read all of the assembly and operation instructions before use.
Warning: All procedures should be performed by an experienced mechanic with proper tools and training. Failure to do so could result in
great bodily injury or death. Carburetor or throttle body synchronization should be done in accordance with the factory shop manual for your
vehicle. Follow all instructions and specifications in your manual.
1. Connect the hang hook to the SyncPRO™ and close the small
loop with a pair of channel locks to prevent it from inadvertently
coming off when in use (Image 1).
2. Cut the long piece of vacuum hose into four equal lengths.
Remove the vacuum caps on top of the clear tubes (Image 1) and
attach the vacuum hoses onto the clear tubes. If the vacuum hose
is difficult to install, moisten the end of the vacuum hose with a drop
of water and twist into place
Install a restrictor (Image 2) in the other end of each vacuum
hose. The tapered end of the restrictor should be inserted into the
vacuum hose first (Image 3).
IMAGE 1
IMAGE 2
IMAGE 3
Push the restrictor approximately 3/8” into the vacuum hose with
one of the barbs on the calibration manifold (Image 4 & 5).
IMAGE 4 IMAGE 5
The restrictors should now be located on the ends of the vacuum
hoses that will be connected to the intake manifold or carburetors.
3. Remove the rubber plugs from the bottom of the SyncPRO™
and store the manifold adapters in the body of the SyncPRO™
(Image 6).
4. Cover one of the six ports on the calibration manifold with a vacuum
cap. Then plug the calibration manifold into the short vacuum hose
and attach it to the side of the SyncPRO™ (Image 7).
IMAGE 6
IMAGE 7
I08-0411 5/2014 1 of 3