Motion Pro 08-0415 User Manual
Page 4
I08-0415
4 of 4
03/2010
9
.
9. Place the reservoir in the housing, and check one last time that the o-rings and tubes are still fully
seated before you put the housing back together. Starting with the innermost screws and working
outward, gently hand-tighten each screw until the housing is closed around the entire perimeter.
Replace the rubber feet. Your SyncPRO™ is now ready for use. Remember to check and set
your engine idle to the proper RPM before hooking up the SyncPRO™ for its next use.
8. Make sure the calibration screws and o-
rings are free of debris and then thread
them down gently by hand until they
bottom out. They do not need to be
tight.
8
See also other documents in the category Motion Pro For motorcycles:
- Mercury (2 pages)
- Revolver Throttle (1 page)
- Revolver Push Pull Throttle Kit (4 pages)
- 01-2569 (1 page)
- 01-2512 (1 page)
- 01-0329 (2 pages)
- 01-0316 (1 page)
- 01-0313 (2 pages)
- 01-2662 (2 pages)
- 01-0390 (1 page)
- 01-0339 (2 pages)
- Generic Throttle Kit (2 pages)
- 01-0579 (1 page)
- 01-0378 (1 page)
- 01-0337 (2 pages)
- 01-0152 (1 page)
- 01-0053 (1 page)
- 01-0054 (1 page)
- 01-0056 (1 page)
- 01-0057 (1 page)
- 01-0063 (1 page)
- 01-0107 (1 page)
- 01-0703 (1 page)
- 01-1198 (1 page)
- 11-0057 (4 pages)
- 01-2661 (1 page)
- 08-0019 (1 page)
- 08-0058 (4 pages)
- 08-0066 (1 page)
- 08-0071 (1 page)
- 08-0072 (1 page)
- 08-0075 (1 page)
- 08-0120 (1 page)
- 08-0121 (1 page)
- 08-0122 (1 page)
- 08-0126 (1 page)
- 08-0134 (2 pages)
- 08-0135 (2 pages)
- 08-0140 (1 page)
- 08-0141 (1 page)
- 08-0143 (1 page)
- 08-0188 (1 page)
- 08-0213 (1 page)
- 08-0292 (1 page)
- 08-0294 (3 pages)