Motion Pro 08-0415 - Manual

I08-0415 1 of 4 03/2010
08-0415 SyncPRO™ Manometer Fluid Refill Instructions
Thank you for purchasing Motion Pro SyncPRO™ Replacement Manometer Fluid. In the event excess
vacuum was placed on the SyncPRO™, fluid from all four chambers may be drained from the reservoir.
(NOTE: If you experience fluid loss from only one chamber, please contact Motion Pro to determine if there
is a problem with your SyncPRO™ before refilling it.) The following steps will guide you through the
procedure for replacing fluid that was lost during calibration or synchronization.
Have the following items handy before you begin: #1 Phillips screwdriver, a small flat blade
screwdriver, running water, paper towels and compressed air.
.
2
A
B
2. Remove the reservoir with tubes still in
place (A). Remove the four calibration
screws (B) and place them aside in a
clean area.
1
1. Place the SyncPRO™ face
down on a clean non-
scratch surface with ample
working
space. It is
important to keep your
work area clean so you
don’t introduce debris into
the unit during reassembly.
Turn the four calibration
screws clockwise until they
stop turning. Remove the
rubber feet and eleven
screws that hold the two-
piece housing together.
Separate the housing.