Microtel D51T v.1.0 - Manual (Page 21)

MICROTEL D51T
19
This section details operation of the dialer, from both local and remote locations.
Sections will detail the following actions:
 Alarm Acknowledgment
 Checking System Status
 Controlling the local output relay
Alarm Acknowledgment
When D51T calls you, you may wish to respond to the call differently depending on what
type of alarm has occurred, who is on duty, the time of day, severity of the alarm, etc.
If you wish the dialer to go to the next phone number on its calling list, hang up the
phone. The dialer will continue on after the call spacing delay to the next phone number
on the list until it receives an acknowledgment or the unlatched alarm goes away by
itself.
If you wish to acknowledge the call from your touch-tone phone, press the ‘*’ key on
your telephone while the alarm message is being spoken. The dialer will respond by
reporting that the alarms are acknowledged. If you then need access to the remote
programming commands, enter the 2 digit access code when D51T prompts you. After
gaining access to the dialer, you may review or modify any of the dialer’s configuration
data.
NOTE: If you don’t have a touch-tone phone, you can acknowledge the alarm call by
hanging up the phone and calling the dialer back within the call-spacing period
(One minute). When the dialer answers the telephone call, all fault conditions
will be acknowledged.
Checking System Status
D51T allows for easy checking of system status and capability. Spoken reports of your
entire dialer-monitored system can easily be generated.
A spoken system status report can be received from the dialer by entering the following
command from a touch-tone telephone either locally, or remotely after answering or
calling the dialer: The dialer will speak a voice message of system name and current
alarms or normal status. It will also report the current temperature and local output state
IF the local output has been manually controlled.
 System Status Gives a complete status of all points monitored by the dialer
*00 Report system status