Maxim Integrated 73M1822/73M1922 Modem CTL Application - Manual (Page 6)

73M1822/73M1922 Modem CTL Application User Guide UG_1x22_056
6 Rev. 1.0
1.2 Modem CTL Command Summary
Entering tsc_1x22_app at the command line brings up the Modem CTL program. Refer to the
individual command descriptions in
Section 2 for syntax and usage.
When running the Modem CTL program displays the following prompt:
1X22CTL:XX> where: XX is the current active channel.
Upon startup the current active channel is defaulted to channel 0. In which case the prompt will look like
this:
1X22CTL:00>
Most commands, without specifying channel number, apply to current active channel. However, some
commands provide options for selecting a desired channel (other than the current active channel).
Table 1 provides an overview of the commands implemented in the Modem CTL Application.
Table 1: Summary of Modem CTL Commands
Command Syntax Description
? Displays the Help screen – same as the Help command.
autoanswer
Sets channel to auto answer mode. When set, the application automatically
answers the incoming RING by going off-hook and performs PCM parameter
setting.
answer
Manually answers a call. This command manually answers the RING by going
off-hook and performs PCM parameter setting.
billingtonefilter Billing tone filter disable/enable command.
callmonitor Managing the setting of call progress monitor audio.
channel Sets active channel ID.
countryconfig Managing the default country setting parameter.
dial Performs pulse dialing.
display Not implemented.
exit Exits the Modem CTL program.
gpio Managing GPIO operation.
help Displays the Help screen.
iet
Interval Event Table. Used to manage the IET table such as list active IET
entries, delete entries and update IET entries.
loopback Managing loopback operation.
measure
Measures voltage/current. This command initiates or terminates voltage or
current measuring session.
offhook Takes an FXO channel off-hook.
ohhook Takes an FXO channel on-hook.
register Manages the 73M1x22 internal registers (read/write).
threshold Modifying line parameter threshold.
quit Same as exit.