Longshine LCS-KL-2716M - Manual (Page 24)

23
6.1.6 Auto-Scan Function
When you enable Auto-Scan function by pressing twice, then
and . The KVM Switch will shift through all the ports and display
them on the monitor.
The mouse and keyboard will be disabled under this mode. This is necessary to
prevent errors such as erratic movement and wrong characters to display when
using the mouse or keyboard in accident.
Start auto-scan function
→
→ → → → → → → → → → → . The auto-scan
banner will be shown to indicate the scanning channel.
Auto-scan hot key
─┬── ┬ ──┬──────
│ │ └─
Channel Name
│ └──────────
Channel Number
└─────────────── Indicate now is Scan Mode
Auto-scan Banner
6.1.7 Stop auto-scan function
Press any key on keyboard to STOP the auto-scan function. Press the push
button on KVM front panel to select active port can stop the auto-scan
function too.
6.1.8 Auto-scan mode
There are two auto-scan modes, please refer section 7.3.1 Setup in OSD –
Scan Mode to setup the auto-scan mode.