Leitz Diamaster WhisperCut - Manual (Page 11)

Deuts
ch
Engli
sh
中
文
Ita
lia
no
Fr
ançaise
Espa
ñol
Po
rt
uguê
s
Ру
сс
кий
11 04/2012 ID.524571 V2.0
Detergents can irritate skin and eyes and damage the tool or clamping device.
Only use detergents, which do not corrode the material, e.g.Sur-Tec 194 for steel resp.
Sur-Tec 143 for aluminium and steel.
The appropriate detergents and care products can be obtained from the tool manufacturer
Follow the instructions of the detergent manufacturer.
Woodworking tools and clamping devices are to be protected against humidity in order to
avoid corrosion.Adequate detergents and care products: multi-purpose oil, e.g. WD 40 or
Ballistol
1.6 Servicing, modifying, sharpening
1.6.1 General instructions
Service and modifications are only allowed to be done by the manufacturer or by
authorized professional workshops.
Danger of tool breakage.
Only those replacement parts are allowed to be used, which match the requirements of
the original replacement parts of the tool manufacturer.
Tolerances, that guarantee a precise clamping, have to be kept.
Sharpening, repairing or modifying of tools is only allowed to be done by experienced
specialists as per the instructions of the manufacturer.
Specialists must have knowledge and experience of:
- up-to-date engineering standards in the design and construction of woodworking tools
- national rules and regulations
- relevant safety regulations and standards
- and have the necessary machinery and the required skills to undertake the task
After any sharpening, repairing or modifying, it shall be guaranteed, that the tool meets the
requirements of the European Standard EN 847-1.
Tool labellings, which have been affected by modification / re-tipping, have to be updated.
Name/ logo of the modifying / re-tipping company have to be added.
1.6.2 Sharpening instruction
Ask the tool manufacturer for the sharpening instruction.